How to change the Indicator Light bulbs on the Aygo
Locate the connector which is behind the headlamp, directly behind the indicator bulb itself. The bulb holder itself is grey.
Remove (you may need to use the flat head screwdriver) the wire locking tab on the connector, and pull it off (don’t lose it).
Twist the unit anti-clockwise and withdraw the bulb holder. It is a tight fit so might need some elbow grease.
You'll see then see the bulb. Push the old bulb inwards and rotate anti-clockwise, as you would a normal bulb.
Then
replace with the new bulb in the same way! Place the connector back in
and secure with the locking tab, and twist back into place.
No picture of the how to but a picture of the after!!
Top Tip: Start
with the left indicator as it is easier to access, the right one is
behind the battery and harder to locate and you may need to twist off
the unit before removing the locking pin as it is difficult to reach.
Parts Required: Offset Chrome Indicator Bulb
Tools Required: Flathead screwdriver
Time Estimated to Complete: 15 mins
Submitted by: SJandAYGO
<< Return to the Aygo Knowledgebase
|
