Toyota Aygo Club Knowledgebase

How to change/replace your interior light bulb on the Aygo

Step 1

First of you need to pry the light away from its fixing by lodging a flat blade screwdriver into the slot shown in the photo below: -

Step 2

Then once you've pulled it out you can then choose to either leave it connected to its harness or unplug by removing the green plug seen below (i left it in as it's a fairly quick job).

Remove the bulb holder from the light lens housing by pushing in the grey clips where my fingers are: -

Step 3

Once done you then have access to the bulb - simply pull it out...

Step 4

And then install the new one, and for this i've installed a 4 LED Blue bulb in mine. (Note: If you insert a wedge-style LED equivalent and notice it doesn't work, pull it out and rotate it 180 degress. I noticed this when i installed it for the first time)

Step 5

Now once the bulb has been inserted it's time to fit the bulb holder back into the light lens housing through the corresponding hole below: -

Step 6

Once the bulb holder and lens housing have clicked back together, it's a simple matter of putting it back in. You first of all angle it like i have below, make sure the black light toggle switch is pushed to the left and then push the other end up to click the whole thing back into place like the arrows demonstrate: -

Horizontal arrow first then vertical arrow second

Step 7

Admire your handy work!

Submitted by: Paul GI

<< Return to the Aygo Knowledgebase